It will be new: 5 ways to clean the plastic cutting board

Even a dishwasher cannot do much. But there are several methods to get rid of dirt – these are the tips you can try.

Surprised that barking bark with vinegar, not soda? The fact is that it consists precisely of sodium bicarbonate and acid salt – for example, citric acid.

To clean the plastic cutting board, you must mix the baking powder and white vinegar at 9% in an equal proportion, apply on spots, leave for five minutes, then rinse.

Alas, a simple hack gives poor results – on a white board, the spots will become lighter, but will not disappear. But there are good news: vinegar disinfects plastic, therefore from the point of view of hygiene, cleaning will be quite effective.

Mix a glass of water (ideally distilled) in a spray gun, a glass of white vinegar at 9% and five to seven drops of your favorite essential oil. Shake the bottle, sprayed the contents on the board, rub it with a hard brush, then wash with liquid for dishes.

The solution will give a slightly better result than a mixture of vinegar and baking powder, and can be an alternative to bleach, which is preferable to stay away from kitchen utensils, but will not face stains. But it will be incredible to feel in the kitchen, and you will also have a universal spray that can be cleaned almost everything.

Cut the lemon in half, wipe the board carefully with them, tighten the juice over it, then put it in the street under the sun’s rays throughout the day.

The sun is an excellent bleach, but the result still leaves something to be desired: the stain on the white board will remain, although it becomes almost invisible. And, of course, hack’s practicality leaves a lot to be desired: wait until the ultraviolet will act, it is necessary for too long.

Mix three or four tablespoons of soda bicarbonate in a bowl, a tablespoon of water washing fluid and one or two spoon of hydrogen peroxide. Apply the mixture on site and leave it at night, in the morning, wash the product with warm water.

In the morning, the solution will stretch all the particles of the spot on the surface – there will be almost no traces.

First, the Spray on the board is a mixture of white vinegar at 9% and water in equal proportions or 3% hydrogen peroxide. Wait for five minutes, then wash the board with water and soap. After that, prepare the dough from part of the baking soda, part of the salt and part of the water and the remaining points.

It is the best experienced way of cleaning the plastic cutting board of the pollution: this requires a little effort, but the result is worth it.

Even more interesting materials – in our Telegram.